HELP! z3m rear end

[ajoystick]

Many have discussed an entire rear subframe assembly from a z3m.
What specifically does this include? is it just the differential halfshafts and trailing arms (and all that is attached such as brakes, calipers ect) or does this include the rear axle carrier (part # 33312228200 on realoem)?

The reason i ask this is i have access to the entire rear end besides the passenger side trailing arm (only the caliper, rotor and shock are still available on the passenger side)

should i purchase the drivers side + Differential and hope to find the passenger side?

Is there a way AT ALL to adapt the caliper w/ rotor?

If i get a z3m diff can i simply swap the input flange from my old diff to the z3m diff to make it bolt up to my old driveshaft?

Will the z3m halfshafts work with the stock trailing arms on my Ti?

Any help would be greatly appreciated

[ajoystick]

bump

[JeroenB3]

No, I should not buy it if a trailing arm is missing.
I bought a complete set, but one trailingarm wasn't good, I needed to buy a new trailingarm at the dealer... € 750,- ... bare !!

The half shafts are bigger, so they don't fit on the ti trailingarms.
The callipers and rotor won't fit either, much bigger.

The only part you don't really need is the axle carrier.

[ajoystick]

i guess i luck out, the input flange is a 4 bolt on the 98' M roadster i am yanking the parts from. so the swap will be easier than expected.

[JeroenB3]

That is the only fitting part, output flanges are bigger.