318ti.org forum

Go Back   318ti.org forum > Classifieds > For Sale > US and North America > Parting out & Parts (US)

Notices

Parting out & Parts (US) Cars being parted out and misc parts only!

.
» Recent Threads
Knock Sensor Error &...
07-07-2019 05:42 AM
Last post by MisterM52
Today 06:16 AM
7 Replies, 482 Views
M44 Supercharged Project...
04-07-2019 06:54 AM
Last post by steve f
Today 01:46 AM
9 Replies, 1,759 Views
Oil Filter Housing Leak...
02-14-2008 08:21 PM
Last post by shriberone
Yesterday 09:59 PM
119 Replies, 84,986 Views
H&R Race springs and...
06-26-2019 09:46 AM
Last post by Denteen
Yesterday 12:07 AM
1 Replies, 718 Views
97' M-Tech Edition...
08-30-2018 06:51 PM
Last post by dudecati
07-17-2019 11:06 PM
13 Replies, 3,252 Views
1996 332ti supercharged...
06-08-2019 08:27 PM
Last post by slowoldpoop
07-16-2019 07:59 PM
6 Replies, 1,868 Views
Mostly new to cars and a...
07-11-2019 09:28 PM
Last post by paul somlo
07-16-2019 02:33 AM
4 Replies, 578 Views
318to supercharger kit
07-15-2019 09:39 PM
Last post by jacksondnm02
07-15-2019 09:39 PM
0 Replies, 285 Views
Seeking 318ti with...
06-30-2019 07:36 PM
Last post by Trusted-1
07-14-2019 07:26 PM
7 Replies, 1,387 Views
TWO! 1996 California Top...
07-14-2019 07:25 PM
Last post by Trusted-1
07-14-2019 07:25 PM
0 Replies, 326 Views
Reply Share/Bookmark
 
Thread Tools Display Modes
Old 07-21-2018, 07:28 PM   #1
pilsberry
Member
 
Join Date: Aug 2003
Location: ATL
Posts: 43
Vehicles
iTrader: (0)
Default M44 engine, 5 spd trans, Diff. ATL

I swapped in an S52 and a 6 speed, so I need to get rid of the leftovers. This 1999 engine/trans has about 178K on it. The engine needs rod bearings and most likely a head gasket. It was running great with no check engine with syptoms I have mentioned. Was getting 31 mpg in mixed driving. The crank is fine, and the #2 (bad bearing) checked good with plastigauge and robbing an existing bearing from another rod. 5 speed Roswell, GA 30075

Engine 150

5 speed Trans 200

Stock (open) diff 75

Front half of drive shaft with balance ring SOLD

Cat portion of exhaust 50

Radiator 50

Elec fan 75

Air box 30

MAF 45

ASC throttle body 35

Sway bar (front) 75

Dual mass Flywheel <1000 miles of use Luk DMF 017 190

Luk Clutch kit 03-028 clutch,disc,throwout bearing <1000mi. 80

Instrment cluster 50

Half shafts (one torn boot) 30 for both

Also have engine stand and lift available after engine is sold.

Also available is rear trailing arms , springs, and half shafts from 01 Z3 sport.

PM or email

Thanks,
Bryan

Last edited by pilsberry; 08-02-2018 at 07:30 AM.
pilsberry is offline   Reply With Quote
Old 07-30-2018, 08:06 PM   #2
fastworker
Member
 
Join Date: Jul 2006
Location: So Cal
Posts: 35
iTrader: (0)
Default

Hi - left msg on your FB post as well - need your front half of the driveshaft, with the balancer. Also, if possible the output flange from the 5 spd. ship to 92637 - thanks, Kent
fastworker is offline   Reply With Quote
Old 08-08-2018, 03:11 PM   #3
fastworker
Member
 
Join Date: Jul 2006
Location: So Cal
Posts: 35
iTrader: (0)
Default

Just an atta-boy for this seller - bought the front prop shaft, and he threw in an as new Guibo as well. Many thanks!
fastworker is offline   Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
318ti use Z3 DME for SAP delete and emissions delete new318tifan Engine 5 02-03-2016 03:24 PM
1996 318i 5 speed M44 engine runs on at higher speeds only Cape Bob Engine 8 02-01-2016 02:23 PM
328ti Post Swap Analysis BMW_Hatchback Engine Swaps 6 06-29-2011 06:12 AM
NJ 94 318ic engine and trans sale dreamracerX US and North America 0 03-05-2011 01:48 AM
Stock 1.9 M44, trans, exhaust, rear arms Junk US and North America 11 04-29-2010 02:47 PM


All times are GMT +1. The time now is 03:10 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2019, 318ti.org
© vBadvanced CMPS v3.2.2
[page compression: 73.09 k/84.58 k (13.59%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.