318ti.org forum

Go Back   318ti.org forum > Technical, Maintenance and Modifications > Engine Swaps

Notices

Engine Swaps Engine conversions.

.
» Recent Threads
Save this ti
06-19-2021 06:59 AM
Last post by b0m
06-19-2021 06:59 AM
0 Replies, 305 Views
Partial Interior Part out
05-23-2021 09:40 PM
Last post by lumitrac
06-17-2021 03:43 PM
14 Replies, 4,570 Views
What sensor does OBD2...
06-12-2021 12:24 AM
Last post by paul somlo
06-12-2021 12:32 AM
1 Replies, 1,333 Views
FS: 1996 slicktop 318ti...
06-02-2021 02:35 AM
Last post by automaton
06-11-2021 03:30 AM
1 Replies, 2,664 Views
  Share/Bookmark
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 12-18-2019, 02:13 AM   #1
ilillund83
Junior Member
 
Join Date: Jun 2009
Location: California
Posts: 15
iTrader: (0)
Default S52 swap fuel pressure question / fuel trim

Hey all, my s52 is in and runs great but I had a quick question. I did not replace the fuel pressure regulator or the fuel pump (3bar vs 3.5). Should I? I would not worry about it except I am having a hard time passing CA smog due to high hydrocarbons only at idle.

It seems to me that if it were a low fuel pressure issue I would notice problems higher in rpm and under load in general. On the other hand I thought that it could also be caused by the computer opening the injectors longer to compensate for the lower overall pressure and the fuel trims not reacting fast enough when rpm drops to idle and dumping more fuel than needed causing the high HC issue. ( I might be WAY off on this and could use guidance! )

Thus far I have smoke tested the vacuum system, replaced all injectors, new o2's, new coils and plugs, and quite a few other things but no dice. The computer is clean, all monitors are ready with no faults and the car seems to run flawlessly.

One last bit of info, My long term fuel trims on bank 1 and 2 are +11.7 ( My assumption was this is also caused by the 3bar pressure regulator but again I may be off base here )

Sorry for the long read just trying to get info out there, any and all suggestions would be appreciated!
Attached Thumbnails
Click image for larger version Name:	IMG_20191206_152941.jpg Views:	51 Size:	86.2 KB ID:	17807  

Last edited by ilillund83; 12-18-2019 at 02:16 AM. Reason: Add Photo
ilillund83 is offline   Reply With Quote
 

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
S52 swap EVAP question ilillund83 Engine Swaps 5 10-29-2019 11:02 PM
New Member s52 Swap cnaville210 Engine Swaps 34 08-05-2012 11:22 PM
Just finished swap, need help! No fuel! Hawkster Engine Swaps 10 03-25-2006 07:40 AM
fuel pressure regulator mightymax Engine 17 01-11-2006 03:35 AM
Fuel pressure gauge on fuel rail? DustenT Engine 3 12-15-2005 06:43 PM


All times are GMT +1. The time now is 01:34 AM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2021, 318ti.org
© vBadvanced CMPS v3.2.2
[page compression: 97.04 k/105.86 k (8.33%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.