318ti.org forum

Go Back   318ti.org forum > Technical, Maintenance and Modifications > Engine

Notices

Engine Tuneups, chips, wires, spark plugs.

.
» Recent Threads
FS: Racing Dynamics RGR...
Yesterday 03:29 AM
Last post by 7Senna8
Yesterday 03:29 AM
0 Replies, 372 Views
My 318ti build
05-21-2024 04:48 PM
Last post by Jclare318ti
05-21-2024 04:48 PM
0 Replies, 962 Views
Reply Share/Bookmark
 
Thread Tools Display Modes
Old 07-15-2006, 11:09 PM   #1
themysteryman83
Junior Member
 
Join Date: Nov 2005
Location: Dallas, TX
Posts: 21
iTrader: (0)
Default Knock sensor code with knocking problem

So i'm driving my 98 318ti (m44) home last night and I noticed that my car's engine starts to chatter quite a bit. It's never done this before. So I think hmm ok maybe it will go away. In the morning it doesn't do it. The check engine light procedes to come on and i'm like sh!t. Still no chattering though. Then on the way back home again today it starts to do it again but not as bad as last night. I went to go the codes checked and apparently both the knock sensors are faulty??? Would it be possible for both of them to go out at the same time?? Is there any other problems that might cause this code? Anyone else has this problem? Please folks, any help would be greatly appreciated! Also, to replace them it looks like I have to take off the intake manifold? Is this correct?

Ian
themysteryman83 is offline   Reply With Quote
Old 07-16-2006, 12:52 AM   #2
robcarync
Senior Member
 
robcarync's Avatar
 
Join Date: Aug 2003
Location: cary, nc
Posts: 2,259
iTrader: (0)
Default

yes it is correct.... you will need to remove the upper and lower manifolds. whether they both go out or not, while you have the manifold removed it would make sense to replace both so you wont have to rip the manifold apart for a while. it would suck if you only replaced one ... and a few months later the other one goes out.
__________________
1995 318ti Active
Pioneer Speakers [] Aluminum Billet door locks [] ACS Pedals/Deadrest [] ACS Shift Knob / E-Brake Handle [] Clear Corners/Tails/Sides [] Sylvania Exterior Lighting [] Custom CAI [] Dinan Engine Chip [] Dinan Transmission Chip [] H&R Race Springs [] Tokico Illumina Shocks [] BMW X-Brace [] Relocated Lighter Mod [] Custom iPod Mod
http://www.cardomain.com/id/robcarync
robcarync is offline   Reply With Quote
Reply

Bookmarks


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
E46 Ti - Front speaker replacement using existing speaker housing and standard 6.5" vatovey Knowledge Base 4 01-29-2010 11:51 AM
bulb help classicronnie Exterior 9 12-27-2007 10:54 PM
Standard H1 Bulb Or ...... Tyler Exterior 16 01-13-2007 07:55 PM
Difference between standard and Sport susp? PeteN95 Suspension 5 09-20-2006 08:01 PM
Standard for Standard Diff Swap stormos Differentials 4 03-14-2006 11:33 PM


All times are GMT +1. The time now is 02:21 PM.


.
Powered by site supporters
vBulletin Version 3.8.8
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©1999 - 2024, 318ti.org
© vBadvanced CMPS v3.2.2
[page compression: 61.68 k/71.37 k (13.57%)]

318ti.org does not warrant or assume any legal liability or responsibility for the accuracy, completeness, or usefulness of any information or products discussed.