» Site Navigation | | » Recent Threads | | 1999 M3 Swap 09-07-2023 10:10 PM 06-01-2024 03:04 PM 7 Replies, 409,778 Views | | My 318ti build 05-21-2024 04:48 PM 05-28-2024 06:42 PM 1 Replies, 3,482 Views | | OMG!OMG! 05-28-2024 08:53 AM 05-28-2024 08:53 AM 0 Replies, 1,383 Views | | | | | 11-04-2004, 09:09 PM | #1 | Senior Member Join Date: Jul 2004 Location: Tampa Posts: 465 | Finally bought the roll bar... Anyone have a clue how to install that Bad boy??? do I need to remove the carpeting n full??? | | | 11-04-2004, 09:17 PM | #2 | Member Join Date: Dec 2003 Posts: 50 | You said it was a track car, aren't you going to remove the carpet anyways? But, no, you don't have to, but you will need to at least cut out the carpet where the base plates will go. | | | 12-07-2004, 07:46 PM | #3 | Senior Member Join Date: May 2004 Posts: 411 | how much did you pay? where did you buy it? | | | 12-08-2004, 03:13 AM | #4 | Senior Member Join Date: Jun 2003 Location: Greenville, SC Posts: 9,356 | I remember a writeup in the Roundel. Maybe Phil Marx has a pdf of it? __________________ ...steven BMW CCA #146825 1996 BMW 328ti • 2003 MINI Cooper S • 2016 M235i www.bmwcca.org | | | 12-08-2004, 04:18 PM | #5 | Senior Member Join Date: Jul 2004 Location: Tampa Posts: 465 | Thanks for the tips... it will be a daily driver and planning to track it too. I paid $212 from the add replied to me. It is an HMS powdercoated black. I wish it was like Jared's... the center cross bar can be removed so people can sit on the back.. or easy access to rear seat. mine it bolt on aswell but can't remove the center cross bar. Also... reclining the seats will be impossible. My car should be coming out of the shop any time now.. new ignition coils, AA chip, and the "wierd shorcut" fixed... but at this point the shorcut has not been found. Basically the car idles perfect, and all of a sudden.... everything goes NUTS!. If I apply little pressure to the CHIP, that's when it happens. It is feeding a bad ground to the ground lead from the DME to the DME RELAY and makes everything on PIN #54 (injectors, tank vent valve, vanos solenoid, and idle cont. vlve) freak out. It's been at the shop for over 2 months now... and no solution to it... it already blew up a set of coils and a DME (the insides of the coils UZED out melting off the coil!!) the codes are: 1)power supply voltage 2)memory | | | 01-06-2005, 04:49 AM | #6 | Senior Member Join Date: Jul 2004 Location: Tampa Posts: 465 | | | | | Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | | Posting Rules | You may not post new threads You may not post replies You may not post attachments You may not edit your posts HTML code is Off | | | |
All times are GMT +1. The time now is 05:49 PM.